APC Smart-UPS VT 30kVA 208V w/4 Batt. Mod., Start-Up 5X8, Internal Maint Bypass, Parallel Capability – SUVTP30KF4B4S
AED 48,473.00 excl. VAT
⚠ This Product Is Discontinued.
Out of stock product
APC Smart-UPS VT 30kVA 208V w/4 Batt. Mod., Start-Up 5X8, Internal Maint Bypass, Parallel Capability – SUVTP30KF4B4S
Overview
SUVTP30KF4B4S Features
APC Smart-UPS VT 30kVA 208V w/4 Batt. Mod., Start-Up 5X8, Internal Maint Bypass, Parallel Capability
-
Parallel-capacity capableIncreases total power capacity by using multiple uninterruptible power supplies simultaneously.
-
Parallel-redundant capablePower the connected equipment with multiple uninterruptible power supplies to increase system redundancy
Smart-UPS VTFeatures & Benefits
Serviceability
-
Automatic self-testPeriodic battery self-test ensures early detection of a battery that needs to be replaced.
-
Battery replacement without toolsEnables fast battery replacement, lowering Mean Time to Repair (MTTR).
-
Modular designProvides fast serviceability and reduced maintenance requirements via self-diagnosing, field-replaceable modules.
-
Shippable with modules installedEnables pre-installation UPS staging and testing and faster installation.
Marketing Features
-
Network manageableProvides remote power management of the UPS over the network.
-
Input power factor correctionMinimizes installation costs by enabling the use of smaller generators and cabling.
-
Hot-swappable batteriesEnsures clean, uninterrupted power to protected equipment while batteries are being replaced
-
Scalable runtimeAllows additional run time to be quickly added as needed.
-
Dual mains inputIncreases availability by allowing the UPS to be connected to two separate power sources.
-
Manual maintenance bypassReduces installation costs by eliminating the need for an external mechanical bypass.
Sustainability
-
EU CoC for UPSEnsures that UPSs sold in the EU are highly efficient
Availability
-
Battery modules connected in parallelDelivers higher availability through redundant batteries.
-
Automatic internal bypassSupplies utility power to the connected loads in the event of a UPS power overload or fault.
-
Dual mains inputIncreases availability by allowing the UPS to be connected to two separate power sources.
-
Scalable runtimeAllows additional run time to be quickly added as needed.
-
Generator compatibleEnsures clean, uninterrupted power to protected equipment when generator power is used.
Manageability
-
SmartSlotCustomize UPS capabilities with management cards.
-
LED status indicatorsQuickly understand unit and power status with visual indicators.
-
LCD displayAlpha-Numeric Display which displays system parameters and alarms.
-
Audible alarmsProvides notification of changing utility power and UPS power conditions
-
InfraStruXure Manager CompatibleEnables centralized management via the APC InfraStruXure Manager.
-
Network manageableProvides remote power management of the UPS over the network.
-
Programmable frequencyEnsures compatibility with different input frequencies.
Total Cost of Ownership
-
Intelligent battery managementMaximizes battery performance, life, and reliability through intelligent, precision charging.
-
Manual maintenance bypassReduces installation costs by eliminating the need for an external mechanical bypass.
-
Temperature-compensated battery chargingProlongs battery life by regulating the charge voltage according to battery temperature.
-
Input power factor correctionMinimizes installation costs by enabling the use of smaller generators and cabling.
Protection
-
Cold-start capableProvides temporary battery power when the utility power is out.
-
Safety-agency approvedEnsures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
-
Frequency and voltage regulationGives higher application availability by correcting poor frequency and voltage conditions without using the battery.
Detailed Tech Specification
Output
-
Output power capacity
24.0 KWatts / 30.0 kVA
-
Max Configurable Power (Watts)
24.0 KWatts / 30.0 kVA
-
Nominal Output Voltage
120V , 208V , 208V 3PH
-
Output Voltage Note
Configurable for 208 and 220V – 3 Phase
-
Efficiency at Full Load
93.3 %
-
Output Voltage Distortion
Less than 5% at full load
-
Output Frequency (sync to mains)
57 – 63 Hz for 60 Hz nominal
-
Output Frequency (not synced)
60Hz +/- 0.1% for 60Hz nominal
-
Other Output Voltages
220
-
Load Crest Factor
Unlimited
-
Topology
Double Conversion Online
-
Waveform type
Sine wave
-
Maximum Output Current
92
-
Bypass
Built-in Maintenance Bypass, Built-in Static Bypass
Input
-
Nominal Input Voltage
208V 3PH
-
Input frequency
40 – 70 Hz
-
Input Connections
Hard Wire 5-wire (3PH + N + G)
-
Input voltage range for main operations
165 – 240V
-
Efficiency at Full Load
93.3 %
-
Other Input Voltages
220
-
Maximum Input Current
80.0A
-
Input Power Factor at Full Load
0.98
Batteries & Runtime
-
Battery type
VRLA
-
Included Battery Modules
4
-
Typical recharge time
5hour(s)
-
Nominal Battery Voltage
+/-192 V (split battery referenced to neutral)
-
Expected Battery Life (years)
3 – 5
-
RBC Quantity
4
-
Extendable Run Time
1
-
Extended Run Options
APC-Smart-UPS-VT-30kVA-208V-w-4-Batt-Mod-Start-Up-5X8-Internal-Maint-Bypass-Parallel-Capability
-
End of Discharge Battery Voltage
+/-154 V
-
Runtime
Communications & Management
-
Interface Port(s)
DB-9 RS-232 , Smart-Slot
-
Pre-Installed SmartSlot™ Cards
-
Control panel
Multi-function LCD status and control console
-
Audible Alarm
Audible and visible alarms : configurable delays
-
Emergency Power Off (EPO)
Yes
Physical
-
Maximum Height
1499mm , 149.9CM
-
Maximum Width
523mm , 52.3CM
-
Maximum Depth
813mm , 81.3CM
-
Net Weight
629.09KG
-
Shipping weight
660.0KG
-
Shipping Height
1643mm , 164.3CM
-
Shipping Width
650mm , 65.0CM
-
Shipping Depth
1062mm , 106.2CM
-
Color
Black
-
Units per Pallet
1.0
Environmental
-
Operating Temperature
0 – 40 °C
-
Operating Relative Humidity
0 – 95 %
-
Operating Elevation
0-999.9meters
-
Storage Temperature
-50 – 40 °C
-
Storage Relative Humidity
0 – 95 %
-
Storage Elevation
0-15000meters
-
Audible noise at 1 meter from surface of unit
55.0dBA
-
Online thermal dissipation
6305.0BTU/hr
-
Protection Class
NEMA 1
Be the first to review “APC Smart-UPS VT 30kVA 208V w/4 Batt. Mod., Start-Up 5X8, Internal Maint Bypass, Parallel Capability – SUVTP30KF4B4S”
Related products
AED 1,731.00 excl. VAT
Reviews
There are no reviews yet.